Wi-Fi LED Status Descriptions
Green Connected to a wireless network.
Red, flashing
slowly
Not connected to a network.
Check Signal Strength and Network
Configuration.
Red, flashing
quickly
Speaker is Starting Up.
If this does not change, there may be a
problem, see troubleshooting.
Red / Green
flashing
alternately
The speaker is waiting for or applying
settings, see Configuration pages.
Orange
appears briefly
A reset is being performed.
Orange The speaker is in AQ DIRECT Mode.
Orange,
Flashing slowly
There is a problem with the firmware. Try
resetting the speaker, or perform a
firmware upgrade.
Off AUX IN Mode (if Power LED is on)
Speaker is Off (if Power LED is off)
Getting to Know Your AQ SmartSpeaker
USB Update port: The USB Update port is designed to allow connection of an Apple iOS device for network setup only. DO
NOT connect it to a computer or any other USB device, as damage may occur.
Aux In Connection: When the AQ SmartSpeaker is in AUX IN Mode, you can connect any audio device to the speaker using the
cable provided. Change the mode using the Power/Mode Button on the top of the speaker.
Audio Mode Switch: Set to “M” if it is the only Speaker or if you are using it as part of a multi-room setup. Use “L” and “R” if
you are using two Speakers as a stereo pair.
DC Power Connector: Connect to a mains power socket using the supplied power adaptor to charge the internal battery.
Reset Button: This button will force the speaker to restart if it becomes unresponsive. This will not delete network settings.
Battery Status LED Descriptions
Off When Plugged In: the battery is fully
charged.
When Running on Battery: The battery
is OK.
Blinking
Slow
When Plugged In: The Battery has a
good charge level but is not completely
full, it is being charged.
Blinking
Normal
When Plugged In: The battery is low.
It is being charged.
Blinking
Fast
When Running on Battery: The battery
is low and needs to be charged.
Power/Mode button: Press this button briefly to turn the AQ SmartSpeaker
on.
To switch between modes, with the speaker on, briefly press the Power/Mode button. Repeatedly pressing the button will cycle
through the modes in the following order:
CONNECTED
→ →
AUX IN AQ DIRECT
When the speaker is on, press and hold the Power button for 2 seconds to switch it off.
Volume Up/Volume Down: Briefly Press these buttons to raise/lower the volume by one step.
Mute: Press and hold the Volume Down button for 2 seconds to Mute the speaker. Press and hold Volume Down again to
restore the sound to its previous level. Briefly Pressing either volume button will restore the sound and raise/lower it by one
step.
Pressing and holding the Volume Up button will continuously increase the volume until it reaches its maximum level.
Battery Status LED: The Battery Status LED is
hidden just above the AQ Audio logo on the front of
the speaker. It will flash to indicate the charge status
of the internal battery.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern