Firmware Upgrade Procedure
Occasionally, firmware updates will be released. Check aqaudio.com and download any available update to your computer, then
follow the instructions below to install the update.
The update file itself has the file extension “.fw”, If you have downloaded the file in a .zip package, please ensure you extract it
before proceeding.
To install the update, you will need to access the AQ SmartSpeaker
Setup page.
Before you start, connect your AQ SmartSpeaker
to the power supply. Make sure the AQ SmartSpeaker
is switched on
and connected to the same wireless network as your computer.
NOTE: If you know the IP address of your AQ SmartSpeaker
, simply enter it into any web browser to load the AQ
SmartSpeaker
Setup page, and skip step 1. (Apps are available to help with finding your IP address)
Step 1
Check that you have the latest version of Safari installed on your computer.
Open Safari and open the “bookmarks” sidebar (upper left). Under “collections”, choose “Bonjour”.
Double Click the AQ Smart Speaker XXXXXX in the list under Bookmarks in the centre section. This should load the AQ
SmartSpeaker
Setup page.
Step 2
Choose “Firmware Update” from the menu on the left, then select “Upload a Firmware Update” from the drop-down box and
click “Next” to continue.
Step 3
Click “Choose File” and select the firmware update file you downloaded to your computer, Click upload to copy the file to the
speaker. Depending on the size of the update file, this may take a few minutes.
NOTE: if there is a problem with the file, an error message will be displayed. If this occurs, Click OK, and return to step 3. If
this occurs more than once, please re-download the update file from aqaudio.com, ensuring to extract the .zip if necessary.
Step 4
Click “Install” to start the installation process. Once you have started the installation, it cannot be interrupted. The Power LED
on the top of the AQ SmartSpeaker
will flash whilst the update is installing. Do not attempt to restart the speaker or
disconnect the power until the upgrade is complete.
The speaker will automatically restart when the installation is complete, and the white Power LED will stop flashing.
Step 5
If your AQ SmartSpeaker
fails to connect to your network after the update, you will need to connect your AQ
SmartSpeaker™ to your network again using Options 1 2 or 3.
Bookmarks
Bonjour
Choose Your
AQ SmartSpeaker
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern